Ribbon Blenders for specialty applications
Allowing a full range of customizations, Ross Ribbon Blenders offer practical solutions for specialty and demanding applications. These blenders are widely used for mixing powders, granules and other dry solids, as well as wet applications including suspensions, slurries and pastes. Provisions for vacuum and internal pressure, temperature control, sanitary construction, special requirements for charging and discharging, handling of high density, friable or abrasive materials, spray system for liquid additions, load cells and automated recipe controls are some of the optional features routinely offered.
How the Ribbon Blender Works
Ribbon Blenders consist of a U-shaped horizontal trough and a specially fabricated ribbon agitator. A ribbon agitator consists of a set of inner and outer helical agitators. The outer ribbon moves materials in one direction and the inner ribbon moves the materials in the opposite direction. The ribbons rotate at approx. 300 fpm moves materials both radially and laterally to insure thorough blends in short cycle times. Ribbon agitators are used for blends that will be between 40 and 100% of the rated capacity of the blender.
An alternate agitator is our paddle design. The paddles are positioned to move materials in opposing lateral directions and radially. The paddle design is normally applied where friable materials are being blended and when batches as small as 15% of the total capacity are going to be mixed in one blender.
Ribbon and Paddle designs are available in working capacities to over 515 cu.ft. and in either center or end discharge designs.
Contact US: Antonio
Tel:+0086-17755023213 WhatsApp: +0086-17755023213
Should u have any comments about our machine, please feel it contact by our email:firstname.lastname@example.org